HP HP0-Y43 시험문제

HP인증HP0-Y43시험을 패스하기가 어렵다고 하면 합습가이드를 선택하여 간단히 통과하실 수 잇습니다. 우리ITExamDump에서는 무조건 여러분을 위하여 관연 자료덤프 즉 문제와 답을 만들어낼 것입니다. 우리덤프로HP인증HP0-Y43시험준비를 잘하시면 100%HP인증HP0-Y43시험을 패스할 수 있습니다. ITExamDump덤프로 여러분은HP인증HP0-Y43시험을 패스는 물론 여러분의 귀증한 간도 절약하실 수 있습니다.

ITExamDump HP인증HP0-Y43시험덤프 구매전 구매사이트에서 무료샘플을 다운받아 PDF버전 덤프내용을 우선 체험해보실수 있습니다. 무료샘플을 보시면ITExamDump HP인증HP0-Y43시험대비자료에 믿음이 갈것입니다.고객님의 이익을 보장해드리기 위하여ITExamDump는 시험불합격시 덤프비용전액환불을 무조건 약속합니다. ITExamDump의 도움으로 더욱 많은 분들이 멋진 IT전문가로 거듭나기를 바라는바입니다.

HP인증HP0-Y43시험은 국제적으로 승인해주는 IT인증시험의 한과목입니다. 근 몇년간 IT인사들에게 최고의 인기를 누리고 있는 과목으로서 그 난이도 또한 높습니다. 자격증을 취득하여 직장에서 혹은 IT업계에서 자시만의 위치를 찾으련다면 자격증 취득이 필수입니다. HP인증HP0-Y43시험을 패스하고 싶은 분들은ITExamDump제품으로 가보세요.

ITExamDump 는 아주 우수한 IT인증자료사이트입니다. 우리ITExamDump에서 여러분은HP HP0-Y43인증시험관련 스킬과시험자료를 얻을수 있습니다. 여러분은 우리ITExamDump 사이트에서 제공하는HP HP0-Y43관련자료의 일부분문제와답등 샘플을 무료로 다운받아 체험해볼 수 있습니다. 그리고ITExamDump에서는HP HP0-Y43자료구매 후 추후 업데이트되는 동시에 최신버전을 무료로 발송해드립니다. 우리는HP HP0-Y43인증시험관련 모든 자료를 여러분들에서 제공할 것입니다. 우리의 IT전문 팀은 부단한 업계경험과 연구를 이용하여 정확하고 디테일 한 시험문제와 답으로 여러분을 어시스트 해드리겠습니다.

시험 번호/코드: HP0-Y43

시험 이름: HP (Implementing HP Network Infrastructure Solutions Exam)

HP0-Y43 덤프무료샘플다운로드하기: http://www.itexamdump.com/HP0-Y43.html

NO.1 View the exhibit.
A network administrator wants to configure an HP 5800 switch to place all incoming traffic on the
GigabitEthernet 1/0/1 port in priority queue 3. However, one exception applies. All traffic incoming on that
port that is destined to UDP port 55555 should be forwarded in priority queue 4 and marked with DSCP
32.
Based on the current configurations shown in the exhibit, which further steps must the network
administrator perform? (Select two.)
A. Configure port GigabitEthernet 1>0/1 to trust DSCP
B. Apply QoS policy Policy1 as on inbound policyon port GigabitEthernet 1/0/l
C. Apply QoS policy Policy2 as on inbound policyon port GigabitEthernet 1/0/1
D. Create a OoS Ip-dscp mapthat maps Ip value 4 to DSCP02
E. Undo OoS trust on port GigabitEthernet 1/0/1
Answer: B,E

HP dump   HP0-Y43   HP0-Y43덤프   HP0-Y43

NO.2 A company has a network that includes HP 5800 and 12500 switches. Usage demands on the
company's FTP servers have increased, causing performance issues during peak usage times. While
analyzing link utilization, the network administrator noticed that the most heavily utilized links experience
bursts of congestion, causing them to drop traffic. The links then experience brief periods of low utilization
followed by another burst of congestion. This pattern continues periodically throughout the peak utilization
time.
What should the network administrator do to attempt to create a more efficient traffic pattern on these
links?
A. Configure an outbound traffic policing policy on the ports in question, setting the CIR at about sixty
percent of the ports' capacity and the PIR at about eighty percent.
B. Apply Weighted Fair Queuing (WFQ) or Weighted Round Robin (WRR) scheduling in preference to
Strict Priority (SP) scheduling on the ports in question.
C. Configure inbound traffic policing policies on ports at the core, setting the CIR at about sixty percent of
the ports' capacity and the PIR at about eighty percent. Apply outbound generic traffic shaping (GTS) on
ports facing the core ports, setting the CIR equal to the CIR on the core ports.
D. Apply a WRED table to the ports in question, optionally adjusting the table values to drop lower priority
traffic first.
Answer: D

HP인증   HP0-Y43 pdf   HP0-Y43   HP0-Y43인증   HP0-Y43   HP0-Y43

NO.3 How can a high density of ports and high throughput at the core of an HP FlexNetwork save customers
money?
A. Intelligence is offloaded from the edge switches, enabling customers to save money on the most
numerous switches in their solutions.
B. The customer can combine the data center and campus LAN core into a single entity, reducing power
and cooling costs.
C. The customer no longer needs to deploy modular switches at the distribution level and the edge,
deploying more cost-effective stackable switches instead.
D. The architecture can be simplified, eliminating expensive distribution devices and reducing power and
cooling costs.
Answer: D

HP   HP0-Y43   HP0-Y43   HP0-Y43덤프   HP0-Y43 dump

NO.4 What is the role of neighbor solicitation (NS) messages in the autoconfiguration of an IPv6 address.?
A. An IPv6 node sends an NS message to inform a node undergoing autoconfiguration that it is already
using a particular address.
B. An IPv6 node sends an NS message for its tentative address to determine whether another node is
using it.
C. An IPv6 node sends an NS message for the global prefix to prompt other IPv6 nodes to advertise the
addresses that they are using on that prefix.
D. An IPv6 node sends an NS message to prompt an IPv6 router on the link to advertise the global
prefixes associated with the link immediately.
Answer: B

HP시험문제   HP0-Y43 dumps   HP0-Y43   HP0-Y43

NO.5 A company has a service level agreement (SLA) with its service provider. The SLA specifies a 2 Mbps
committed information rate (CIR) and 20 KB committed burst size (CBS). Lately, during peak usage times,
the company has been experiencing brief periods of poor performance on its external connection
(GigabitEthernet port 2/0/1 on an HP 5800 switch).
How can the network administrator configure the Comware switch to address this problem?
A. Configure a traffic classifier that selects all traffic and a car traffic behavior that sets the CIR to 2 Mbps
and the CBS to 20 KB. Create a QoS policy that maps the classifier to the action and apply this policy as
an inbound policy on port GigabitEthernet 2/0/1.
B. Enable Strict Priority (SP) scheduling on port GigabitEthernet 2/0/1 and ensure that all inbound traffic is
marked with the correct priority.
C. Configure generic traffic shaping (GTS) on the GigabitEthernet port 2/0/1, setting the CIR to 2 Mbps
and the CBS to 20 KB.
D. Configure a traffic classifier that selects all traffic and a car traffic behavior that sets the CIR to 2 Mbps
and the CBS to 20 KB. Create a OoS policy that maps the classifier to the action and apply this policy as
an outbound policy on port GigabitEthernet 2/0/1.
Answer: C

HP   HP0-Y43최신덤프   HP0-Y43   HP0-Y43

NO.6 A network includes a mix of IGMPv2 and IGMPv3 endpoints and must support the following source
specific multicasting applications:
-Source: 10.1.4.2 and Group: 232.0.5.5
-Source: 10.1.4.12 and Group 232.0.6.6
The network is already implementing PIM-SM and IGMPv3. In order to support these applications, the HP
10500 switches that act as routers for the endpoints in question must support another feature. Which step
must the network administrator perform on each of these switches?
A. Create an SSM policy that includes 232.0.5.5 and 232.0.6.6 within its range
B. Enable IGMPv2 backward compatibility mode
C. Configure two SSM maps, each of which mapsa source to its multicast group
D. Enable PIM SSM on the interfaces that connect to the endpoints
Answer: C

HP인증   HP0-Y43최신덤프   HP0-Y43

NO.7 View the exhibit.
The exhibit shows a network with HP 5400 zl and 8200 zl switches throughout the core and edge. What is
one advantage of implementing routing on edge switches?
A. Typically, it is easier to implement user-based VLAN assignments.
B. The topology has higher redundancy because edge switches can take over routing roles when
necessary.
C. Typically, the network can use fewer total VLANs when edge switches implement routing.
D. Typically, it is easier to ensure that routed links between edge and core switches are fully utilized.
Answer: D

HP pdf   HP0-Y43   HP0-Y43최신덤프   HP0-Y43   HP0-Y43기출문제   HP0-Y43 pdf

NO.8 Which switch is best suited to act at the edge of a medium to large HP FlexFabric solution?
A. 10500
B. 5500
C. 9500
D. 5830
Answer: D

HP   HP0-Y43자격증   HP0-Y43   HP0-Y43 pdf

NO.9 View the exhibits.
Exhibit 1
The frame has these characteristics:
-VLANID = 3
-802.1p = 3
-DSCP=32
-Source IP address = 10.1.1.5
Click here for Exhibit 2
The frame shown in Exhibit 1 arrives on an HP 5800 switch's GigabitEthernet port 1/0/1. QoS maps are at
their default settings. Based on the configuration shown in Exhibit 2, to which queue is the outbound
packet assigned?
A. 2
B. 3
C. 4
D. 5
Answer: D

HP시험문제   HP0-Y43   HP0-Y43   HP0-Y43 dump

NO.10 A customer requires an HP FlexCampus solution with a core that scales to 40/100G. Which HP switch
fabric meets this need?
A. the 7500's CLOS switch fabric
B. the 10500's CLOS switch fabric
C. the 7500's crossbar switch fabric
D. the 10500's crossbar switch fabric
Answer: B

HP덤프   HP0-Y43 dumps   HP0-Y43기출문제   HP0-Y43

HP인증 HP0-Y43시험을 패스하여 자격증을 취득하는게 꿈이라구요? ITExamDump에서 고객님의HP인증 HP0-Y43시험패스꿈을 이루어지게 지켜드립니다. ITExamDump의 HP인증 HP0-Y43덤프는 가장 최신시험에 대비하여 만들어진 공부자료로서 시험패스는 한방에 끝내줍니다.